Adhesive Plaster 25KG

Application of Adhesive Plaster

Preparation and Application:
Before starting the application, the surface should be cleaned. Pour a sufficient amount of water into a clean container. Adhesive Plaster is sprinkled until it covers the water surface. Let it sit for a few minutes, then mix until the plaster reaches a homogeneous consistency without any lumps. Once mixed, the adhesive is ready to use. The prepared adhesive can be used for approximately 80 minutes.

After preparing the adhesive, apply fist-sized portions of it every 40 cm along the width of the back side of the Gypsum Board. Apply adhesive in lumps every 20-25 cm (approximately one hand span apart) along the board. For mineral wool applications, the adhesive should be applied every 30 cm and allowed to sit for 60-90 minutes before attaching the mineral wool to the surface.

Attach the Gypsum Board with adhesive to the surface and check its level using a straightedge. For surface gaps larger than 3 cm, pre-shimming should be done.

Recommendations:

• Do not mix Adhesive Plaster with any other products.
• If using a mechanical mixer, use it at low speed.
• Do not add water or plaster after mixing.
• The application environment should have a temperature of at least +5°C.
• Dry and hot surfaces should be moistened before application.

Storage Conditions:
Adhesive Plaster should not be stacked higher than 20 bags. It is recommended to store Adhesive Plaster in a dry, moisture-free, and enclosed environment on pallets, and to use it within 1 year. Poor storage conditions or exceeding the recommended usage time may affect the quality of Adhesive Plaster.